Skip to content
Contact

Fluidzon / Spare parts

Schwab UP 185

Explore the drawing and original articles. Confirm the model and installation generation before selecting a replacement.

Schwab UP 185 model reference

Model reference

Schwab UP 185

9 listed components

Cistern documents
Authorized partner for Schwab service & spare parts

Explore the assembly.

Select a position on the drawing, or find your article below.

8 listed components
Explore flush plate designs & finishes →

Select a drawing position below, or open the drawing to zoom.

Schwab UP 185 manufacturer exploded parts diagram

Drawing positions

Schwab UP 185 / replacement articles

Every part, in view.

Check the article code, cistern generation and connection before ordering.

8 of 8 components

1
Flange gasket for flush valve
351517
2
Gasket for flush pipe
352277
3
Flush valve holder with O-ring
352281
4
Flush valve with gasket (withour lifter), cistern 185
360711
5
Bridge with clip, cistern 185, view 1 of 2
1 / 2
363793
6
Holder
363802
7
Bridge, cistern 185
363818
9
Fill valve 185
675105
Flush plates & finishes

Schwab UP 185 / flush plates

Choose the design. Then the finish.

Match the plate mechanism and installation generation before ordering. Current availability and the correct generation are confirmed on enquiry.

TECTA, white, 241331

2. Finish

241331
  • white
  • Plastic
  • start-stop
  • mechanical

TECTA · white

Material
Plastic
Operation
start-stop
Mechanism
mechanical
Actuation
top on UP185; product property table also says front, but model-specific catalogue and TECTA instruction specify top
EAN
3838912036209
Generation & required hardware

185.000: 1993-1997 (P-IX3671/I), 1997-1998 (P-IX8155/I); 185.1600 since 1999. Top; start-stop.

Existing I2 bridge/retaining clip 363793 and I6 outlet-valve bridge 363818. Instructions 230467 specifically depict 185.1600; older installation procedure not separately verified.

Exact plate mechanism must match; no manufacturer plate revision/cutover date found.

Enquire about this plate ↗
Cistern documents

Cistern drawings and documents

Troubleshooting: find the cause, match the part

Model support

Check the cause. Match the article.

These are inspection references from this model’s parts list, not a diagnosis or a guarantee that replacement is needed. Confirm the generation and drawing position.

Water continues into the bowl

Check the outlet seal and valve seating, fill shut-off and plate adjustment before selecting a replacement.

Slow refill or valve noise

Check supply isolation, filter and fill valve condition. Match the connection thread and installation generation.

  • 675105 — Fill valve 185

    Drawing position 9 · Listed by Schwab for Schwab UP 185. Confirm the installation generation and connection before ordering.

Button loose or not operating

Check the plate mechanism, rods and holders against the model drawing; plate design alone does not establish compatibility.

Technical support · UAE

The right part starts with the right model.

Send a photo of the cistern label, the valve or the old part, plus the year it was installed. We confirm the right article and availability.

Prepare support enquiry Prefer email? [email protected]
Identify my part