Skip to content
Contact

Fluidzon / Spare parts

Schwab UP 80

Explore the drawing and original articles. Confirm the model and installation generation before selecting a replacement.

Explore the assembly.

Select a position on the drawing, or find your article below.

6 listed components
Explore flush plate designs & finishes →

Select a drawing position below, or open the drawing to zoom.

Schwab UP 80 manufacturer exploded parts diagram

Drawing positions

Schwab UP 80 / replacement articles

Every part, in view.

Check the article code, cistern generation and connection before ordering.

6 of 6 components

1
Flush valve with gasket, cistern 80.000
231695
2
Flange gasket for flush valve
351517
3
Flush valve holder with O-ring
352281
4
Flush valve bridge, cistern 80.000
360710
5
Plate with levering mechanism, cistern 80.000
360818
6
Fill valve HDV G 3/8 brass
628458
Flush plates & finishes

Schwab UP 80 / flush plates

Choose the design. Then the finish.

Match the plate mechanism and installation generation before ordering. Current availability and the correct generation are confirmed on enquiry.

GALA, Matt chrome, 227702

2. Finish

227702
  • Matt chrome
  • Plastic
  • start-stop
  • mechanical

GALA · Matt chrome

Dimensions
345 x 180 x 32 mm (published Length x Width x Height)
Material
Plastic
Operation
start-stop
Mechanism
mechanical
Actuation
front
EAN
3838912034625
Generation & required hardware

80.000 1983-1996; start-stop; cannot be converted to dual flush.

Existing I2 bridge 360710 and A2 transparent cover 360818. No dual-flush conversion permitted by manufacturer.

Exact plate mechanism must match; no manufacturer plate revision/cutover date found.

Enquire about this plate ↗
Cistern documents

Cistern drawings and documents

Troubleshooting: find the cause, match the part

Model support

Check the cause. Match the article.

These are inspection references from this model’s parts list, not a diagnosis or a guarantee that replacement is needed. Confirm the generation and drawing position.

Water continues into the bowl

Check the outlet seal and valve seating, fill shut-off and plate adjustment before selecting a replacement.

Slow refill or valve noise

Check supply isolation, filter and fill valve condition. Match the connection thread and installation generation.

Button loose or not operating

Check the plate mechanism, rods and holders against the model drawing; plate design alone does not establish compatibility.

Technical support · UAE

The right part starts with the right model.

Send a photo of the cistern label, the valve or the old part, plus the year it was installed. We confirm the right article and availability.

Prepare support enquiry Prefer email? [email protected]
Identify my part